How does a tensile tester perform tensile tests on bare wires?

     How does a tensile tester perform tensile tests on bare wires? Rally meter has a lot of tests for various industries. Today, Haida technicians will explain how to test the bare wire on a pull meter. The following are the details.

First, the test range

    This method is suitable for testing the tensile properties of wire and cable and other metal conductors and bare wires. After a certain length of test piece is subjected to incremental tensile stress until the sample breaks to test its breaking force and elongation rate after breaking.

Second, test equipment

The indication error is not more than plus or minus one percent.

Third, test preparation

1 , solid core conductor

   ( 1 ) Sampling: 3 pieces of specimens are cut from one end of the inspection sample. The length of the specimen is the length of the original gage length plus twice the grip length of the jaws. Samples must be protected from stretching, twisting, bending, and other equipment damage.

   ( 2 ) Straightening the test piece: Carefully straighten by hand, if necessary, you can also gently tap the test piece with a wooden file. If only the tensile strength is measured, the test piece may not be straightened.

   ( 3 ) Mark the gauge length: Mark the original gauge length 200mm in the middle of the straight specimen. The marking method should not cause early fracture of the specimen, and the marking line should be fine and clear. Gauge length error: positive and negative 0.2mm for hard-wired test specimens, plus or minus 0.5mm for flexible-wire test specimens.

2 , Stranded conductor

   ( 1 ) Sampling: 3 specimens are cut from the samples that pass the inspection. The length of the specimen is the length of the original gauge length plus twice the grip length of the jaws.

   ( 2 ) Specimen processing: Untie the strands at both ends of the test piece, separate and bend into round hooks, and after washing, fill the end of the vertebral body with a low melting alloy or resin. Can also be made by crimping or jigging.

3 , test steps

   ( 1 ) Hold the test piece in the jaws of the device. The mark line should be exposed at the jaws. The position must be such that the longitudinal axis of the test piece coincides with the centerline of the tension.

   ( 2 ) selected stretching speed

   ( 3 ) Turn on the device, and the load should be stable, uniform speed, and no impact.

   ( 4 ) When the specimen is stretched and fractured, read and record the maximum load, taking the 35 effective number. Remove the specimen and carefully align the fracture, squeeze tightly, measure and record the final gauge length.

How does a tensile tester perform tensile tests on bare wires? The above is the test method for bare wires. For users who produce wires, if you think the above content is good, you can not collect them. If there are still other doubts about the above methods, you are always welcome to consult, Haida Instrument will Sincerely at your service.

HDPE bottles offer stronger tensile strength than LDPE containers, are harder and more opaque, and can withstand somewhat higher temperatures: 120°C (248°F) for short periods, 110°C (230°F) for longer periods. High-density polyethylene cannot withstand autoclaving. HDPE (high density polyethylene) plastic bottles offer a mildly stiff impact resistant bottle, with a great moisture barrier. The HDPE plastic bottles are  offered in a great range of sizes, shapes and color.Choose between flip tops, pumps, atomizers or standard lids.

Plastic HDPE Bottle

Plastic HDPE Bottle,1 Oz(30ml) Hdpe Plastic Bottle,Hdpe Plastic Bottle,Bottle Opaque Plastic Bottle

NINGBO LONGTERM INTERNATIONAL TRADE CORP.,LIMTED , https://www.nblongterm.com

Posted on